EQUINOX Software Upgrade
A new Single Frequency of 4 kHz has been added to the existing 5, 10, 15, 20 and 40 kHz options. This new 4 kHz frequency enhances the detection of large deep targets, particularly those found in parts of Asia. As a result of optimising for these conditions, this new frequency may respond differently for users compared to the other single frequencies.
All other single and multi-frequency settings are unchanged in their performance.
In addition to the 4 kHz upgrade feature, various stability enhancements have been included.
Minimum System Requirements:
USB 2.0 port
EQUINOX USB Charging Cable with Magnetic Connector
Windows 10
50 MB of hard drive space
20 MB of RAM
MAC OS
Greater than 10.13 High Sierra
50 MB of hard drive space
30 MB of RAM
Note:
- Only one EQUINOX can be connected to your computer during the update operation.
- The EQUINOX must be ON during the software update.
- Any custom detector settings will be preserved while performing the update.
- An internet connection is required to download the Minelab Update Utility to the computer, however, an internet connection is not required to update the EQUINOX and this can be done offline.
- The EQUINOX coil must be connected to perform the update.
Important: Do not turn off or disconnect the EQUINOX during the update process. For step-by-step instructions on how to install the software update, please refer to the above brochures.
Should you encounter problems with the download, please do not hesitate to contact us on 021 205 5272.